基于混合空穴注入层的湿法制备高效蓝光热激活延迟有机发光二极管

在溶液法制备有机电致发光器件(OLEDs)的研究中, PEDOT∶PSS由于具有较好的成膜性与高透光性而常被用作器件的空穴注入层。但相关研究表明, PEDOT∶PSS本身稳定性较差以及功函数较低,这使得溶液法制备OLEDs的性能差且不稳定。蓝色作为全彩色的三基色之一,制备高效的蓝光器件对于实现高质量显示器件和固态照明装置必不可少。而目前溶液法制备蓝光OLEDs的器件效率普遍较差,针对此问题,本文利用传统的蓝光热激活延迟荧光发光(TADF)材料DMAC-DPS作为发光层,用溶液法制备了蓝光TADF OLEDs,通过在PEDOT∶PSS中掺杂PSS-Na制备混合空穴注入层(mix-HIL)来提高空穴注入层的功函数,研究其对于蓝光TADF OLEDs器件性能的影响。首先在PEDOT∶PSS水溶液中掺入不同体积的PSS-Na溶液,在相同条件下旋涂制膜,进行器件制备。通过观测各个实验组器件的电致发光(EL)光谱,发现掺入PSS-Na后器件EL谱存在光谱蓝移的现象,这是由于掺入PSS-Na水溶液后, mix-HIL层的厚度有所降低,使得在微腔效应作用下, EL光谱发生蓝移。通过对比各组器件的电流密度-电压-亮度(J-V-L)曲线及其计算所得器件的电流效率,结果显示随着PSS-Na的掺入,器件的亮度和电流都有所增大,器件的电流效率也得到了提升,当掺杂比例为0.5∶0.5(PEDOT∶PSS/PSS-Na)时提升幅度最大(亮度提升86.7%,电流效率提升34.3%)。通过在瞬态电致发光测试过程中施加或撤去驱动电压观测了器件EL强度的变化,分析了在混合空穴注入层/发光层(mix-HIL/EML)界面处的电荷积累情况。实验证明,通过在PEDOT∶PSS中掺杂PSS-Na制备mix-HIL获得了蓝光TADF OLEDs器件性能的提升,这是一个获得高效率溶液法制备OLEDs的可行方法。     

Salt effect on molecular orientation at air/liquid methanol interface

The salt effects on molecular orientation at air/liquid methanol interface were investigated by the polarization-dependent sum frequency generation vibrational spectroscopy(SFG-VS). We clarified that the average tilting angle of the methyl group to be u = 308 58 at the air/pure methanol surface assuming a d-function orientational distribution. Upon the addition of 3 mol/L Na I, the methyl group tilts further away from the surface normal with a new u = 418 38. This orientational change does not explain the enhancement of the SFG-VS intensities when adding Na I, implying the number density of the methanol molecules with a net polar ordering in the surface region also changed with the Na I concentrations. These spectroscopic findings shed new light on the salt effects on the surfaces structures of the polar organic solutions. It was also shown that the accurate determination of the bulk refractive indices and Raman depolarization ratios for different salt concentrations is crucial to quantitatively interpret the SFG-VS data.     

Electroactive Metal–Organic Frameworks as Emitters for Self-Enhanced Electrochemiluminescence in Aqueous Medium

Metal–organic frameworks (MOFs) have limited applications in electrochemistry owing to their poor conductivity. Now, an electroactive MOF (E-MOF) is designed as a highly crystallized electrochemiluminescence (ECL) emitter in aqueous medium. The E-MOF contains mixed ligands of hydroquinone and phenanthroline as oxidative and reductive couples, respectively. E-MOFs demonstrate excellent performance with surface state model in both co-reactant and annihilation ECL in aqueous medium. Compared with the individual components, E-MOFs significantly improve the ECL emission due to the framework structure. The self-enhanced ECL emission with high stability is realized by the accumulation of MOF cation radicals via pre-reduction electrolysis. The self-enhanced mechanism is theoretically identified by DFT. The mixed-ligand E-MOFs provide a proof of concept using molecular crystalline materials as new ECL emitters for fundamental mechanism studies.     

介孔钯-硼合金纳米颗粒的制备和甲醇氧化电催化性能北大核心CSCD

合金化可以调节贵金属纳米材料的物理化学性质,从而显著提升它们的电催化性能。尽管合金化在过去的20多年里已取得诸多成果,但是如何充分发挥纳米合金的组分优势仍需深入的探究。本研究通过一步溶液相合成法实现了类金属硼(B)合金化的钯基介孔纳米催化剂材料的合成,同时探究了B原子的组分优势和介孔形貌的结构优势在碱性介质中电化学甲醇氧化反应(MOR)的协同作用。最优PdCuB介孔纳米催化剂表现出优异的电化学MOR活性和稳定性。机理研究表明,优异的催化活性源于B原子在Pd基介孔纳米催化剂中的积极协同作用;该协同作用通过电子效应(改变Pd的表面电子结构从而减弱CO基中间体的吸附)和双功能效应(促进OH_(2)的吸附从而氧化CO基中间体)在动力学上加速了有毒CO基中间体的去除(提高甲醇氧化的决速步骤)。同时,B原子的间隙插入和介孔结构抑制了物理奥斯特瓦尔德(Ostwald)熟化过程,显著增加了催化剂的稳定性。     

Acidity Modification of ZSM-5 for Methane Conversion in Co-feeding Method with MTA Reaction

Acidity plays a vital role in methane conversion by co-feeding method, which is one of the best strategies to improve the utilization and gentle the reaction conditions of methane. In this work, Zn, Ni, Mo, La, Ga, Fe and Co-impregnated ZSM-5 zeolites have been prepared with the same substitutions to variate the acidities and tested in co-aromatization of methanol with methane. It is demonstrated that the new medium-strong acid sites formed by metal and strong acid sites are the key role to activate methane in co-reaction. Zn-modified ZSM-5 catalyst is preferred to exhibit the best methane conversion of 12%, whose aromatic selectivity increases from 27.2% to 52.2% compared with that of HZSM-5. Besides, the addition of methane further improves the production of high-valued aromatics compared with methanol to aromatics (MTA) reaction.     

不同方法制备Pt/C催化剂对燃料电池催化活性的影响

分别采用高压有机溶剂法和回流法不同的制备方法,制备了含铂20%(w)的催化剂Pt/C-HP(高压有机溶剂法)和Pt/C-Reflux(回流法)。实验发现:对于甲醇的阳极氧化过程,高压有机溶胶法制得的催化剂活性较高,催化剂Pt/C-HP甲醇氧化峰电流密度是Pt/C-Reflux的1.5倍,且远远高于商业催化剂JM3000含铂20%(w)Pt/C催化剂,催化剂Pt/C-Reflux甲醇氧化峰电流密度与商业催化剂JM3000催化剂相当。采用X射线衍射(XRD)、透射电镜(TEM)、循环伏安法(CV)等方法对催化剂进行表征的结果表明:高压有机溶胶法制得的催化剂分散性比回流法制得的催化剂好,使得前者催化剂的电化学活性比表面积得到了显著的提高。     

Electrocatalytic activity of porous nanostructured Fe/Pt-Fe electrode for methanol electrooxidation in alkaline media

An electrochemical approach to fabricate a nanostructured Fe/Pt-Fe catalyst through electrodepo-sition followed by galvanic replacement is presented. An Fe/Pt-Fe nanostructured electrode was prepared by deposition of Fe-Zn onto a Fe electrode surface, followed by replacement of the Zn by Pt at open-circuit potential in a Pt-containing alkaline solution. Scanning electron microscopy and energy-dispersive X-ray techniques reveal that the Fe/Pt-Fe electrode is porous and contains Pt. The electrocatalytic activity of the Fe/Pt-Fe electrode for oxidation of methanol was examined by cyclic voltammetry and chronoamperometry. The electrooxidation current on the Fe/Pt-Fe catalyst is much higher than that on flat Pt and smooth Fe catalysts. The onset potential and peak potential on the Fe/Pt-Fe catalyst are more negative than those on flat Pt and smooth Fe electrodes for methanol electrooxidation. All results show that this nanostructured Fe/Pt-Fe electrode is very attractive for integrated fuel cell applications in alkaline media.     

In-line coupling of microextractions across polymer inclusion membranes to capillary zone electrophoresis for rapid determination of formate in blood samples

Polymer inclusion membranes (PIMs) have several important features, i.e., PIMs are dry and non-porous membranes, which can be prepared ahead of use and stored without noticeable deterioration in extraction performance. In this contribution, in-line coupling of microextractions across PIMs to a separation method for clinical purposes was demonstrated for the first time. Formate (the major metabolite in methanol poisoning) was determined in undiluted human serum and whole blood by capillary zone electrophoresis (CZE) with simultaneous capacitively coupled contactless conductivity detection (C⁴D) and UV–Vis detection. A purpose-made microextraction device with PIM was coupled to a commercial CZE instrument in order to ensure complete automation of the entire analytical procedure, i.e., of formate extraction, injection, CZE separation and quantification. PIMs for formate extractions consisted of 60% (w/w) cellulose triacetate as base polymer and 40% (w/w) Aliquat™ 336 as anion carrier. The method was characterized by good repeatability of peak areas (≤7.0%) and migration times (≤0.8%) and by good linearity of calibration curves (r² = 0.993–0.999). Limits of detection in various matrices ranged from 15 to 54 μM for C⁴D and from 200 to 635 μM for UV–Vis detection and were sufficiently low to clearly distinguish between endogenous and toxic levels of formate in healthy and methanol intoxicated individuals. In addition, PIMs proved that they may act as phase interfaces with excellent long-term stability since once prepared, they retained their extractions properties for, at least, two months of storage.     

Measurements and modeling of LLE and HE for (methanol + 2,4,4-trimethyl-1-pentene), and LLE for (water + methanol + 2,4,4-trimethyl-1-pentene)

Excess enthalpy (H^E) for the binary system of (methanol + 2,4,4-trimethyl-1-pentene) (TMP-1) is reported at T = 298.15 K and 101 kPa. (Liquid + liquid) equilibrium (LLE) for the same system is measured at atmospheric pressure (101 kPa). LLE for ternary system of (water + methanol + 2,4,4-trimethyl-1-pentene) is measured at T = (283 and 298) K.The parameters of Non-Random Two-Liquid (NRTL) model were regressed for the system of (methanol + TMP-1) using H^E and LLE from this work combined with isobaric (101 kPa) and isothermal (T = 331 K) VLE data from literature. The NRTL parameters for the binary system of (water + TMP-1) were fitted to a binary LLE data set from literature. NRTL parameters for the binary system of (water + methanol) were taken from ASPEN PLUS. The LLE for the ternary system was modeled by the three binary NRTL interaction parameters systems. The binary and ternary models were compared against the measured data.